Formula map

Labs and electrolytes for nurses: the formulas, worked

Four formulas cover most lab math at the bedside: the anion gap, Na − (Cl + HCO₃); the albumin-corrected anion gap, which adds 2.5 per g/dL of albumin below 4.0; corrected calcium, which adds 0.8 mg/dL per g/dL of albumin below 4; and Cockcroft-Gault creatinine clearance. Each is worked below. Every lab sets its own normal ranges, so this page leaves them to your lab report.

For study and practice only; real results are interpreted with the full clinical picture, the order and your facility’s reference intervals.

What are the core lab formulas at a glance?

One row per calculation, with the worked answer from the example below and the free tool that does it step by step.

Lab formulas, worked answers and calculators
CalculationFormulaWorked answerTool
Serum anion gapAnion gap (mEq/L) = Na − (Cl + HCO₃)24 mEq/LOpen calculator
Albumin-corrected anion gapCorrected gap = observed gap + 2.5 × (4.0 − albumin in g/dL)15 mEq/L (observed 10)Open calculator
Corrected calcium (mg/dL and g/dL)Corrected Ca (mg/dL) = measured Ca + 0.8 × (4 − albumin in g/dL)8.8 mg/dLOpen calculator
Corrected calcium (mmol/L and g/L)Corrected Ca (mmol/L) = measured Ca + 0.02 × (40 − albumin in g/L)2.20 mmol/LOpen calculator
Creatinine clearance (Cockcroft-Gault)CrCl (mL/min) = [(140 − age) × kg × (0.85 if female)] ÷ (72 × serum creatinine mg/dL)about 66 mL/minOpen calculator

How do I read a lab result before I calculate with it?

  1. Check the unit. Calcium in mg/dL and mmol/L differ by about four times, and albumin in g/dL and g/L differ by ten. Every correction formula has a conventional and an SI form.
  2. Use values from the same draw. The anion gap and the albumin correction assume the sodium, chloride, bicarbonate and albumin describe the same moment.
  3. Find your lab’s reference interval. It is printed beside the result. Intervals differ between laboratories and assays, so a number from a textbook table is not a substitute.
  4. Treat corrections as estimates. A corrected value helps you decide what to ask or check next; it does not replace a measured value.
  5. Act on the trend and the patient. Reassess, report as your facility directs and confirm anything unexpected with the prescriber or pharmacist.

How do I calculate the anion gap, and correct it for albumin?

The anion gap is a subtraction from a basic metabolic panel. Enter sodium, chloride and bicarbonate in the same unit (mEq/L) from the same draw. Whether a result is high or low is decided by the reference interval your lab prints, not by a number memorized from a table.

Serum anion gap

Sodium minus the sum of chloride and bicarbonate.

Anion gap (mEq/L) = Na − (Cl + HCO₃)

Worked example

  1. Practice values: Na 140, Cl 104, HCO₃ 12 mEq/L.
  2. Cl + HCO₃ = 104 + 12 = 116
  3. Gap = 140 − 116 = 24

Answer: 24 mEq/L

Compare the result with your lab's reference interval; each lab and assay sets its own. This calculator uses the common form without potassium.

Try it in the Anion Gap Calculator→

Albumin-corrected anion gap

Albumin is the largest unmeasured anion, so a low albumin hides part of the gap. The adjustment adds 2.5 mEq/L for every 1 g/dL the albumin is below 4.0.

Corrected gap = observed gap + 2.5 × (4.0 − albumin in g/dL)

Worked example

  1. Practice values: Na 140, Cl 108, HCO₃ 22, albumin 2.0 g/dL.
  2. Observed gap: 140 − (108 + 22) = 10
  3. Adjustment: 2.5 × (4.0 − 2.0) = 5
  4. Corrected gap: 10 + 5 = 15

Answer: 15 mEq/L (observed 10)

The 2.5 per g/dL slope comes from Figge 1998. The reference albumin used in the adjustment differs between sources; 4.0 g/dL is the common teaching form, so follow your course or lab.

Try it in the Anion Gap Calculator→

How do I correct calcium for a low albumin?

Part of the calcium in blood travels bound to protein, mostly albumin, so a low albumin lowers the total calcium on the report. The correction estimates the total calcium the patient would have at a normal albumin. It is an estimate: when the exact value matters, an ionized calcium measures the active fraction directly.

Corrected calcium (mg/dL and g/dL)

Add 0.8 mg/dL of calcium for every 1 g/dL the albumin is below 4.

Corrected Ca (mg/dL) = measured Ca + 0.8 × (4 − albumin in g/dL)

Worked example

  1. Practice values: calcium 7.6 mg/dL, albumin 2.5 g/dL.
  2. Albumin deficit: 4 − 2.5 = 1.5
  3. Adjustment: 0.8 × 1.5 = 1.2
  4. Corrected: 7.6 + 1.2 = 8.8

Answer: 8.8 mg/dL

Dividing by 4.008 converts mg/dL of calcium to mmol/L: 8.8 ÷ 4.008 is about 2.20 mmol/L.

Try it in the Corrected Calcium Calculator→

Corrected calcium (mmol/L and g/L)

The SI form uses 0.02 mmol/L per 1 g/L of albumin below 40.

Corrected Ca (mmol/L) = measured Ca + 0.02 × (40 − albumin in g/L)

Worked example

  1. Same patient: calcium 1.90 mmol/L, albumin 25 g/L.
  2. Albumin deficit: 40 − 25 = 15
  3. Adjustment: 0.02 × 15 = 0.30
  4. Corrected: 1.90 + 0.30 = 2.20

Answer: 2.20 mmol/L

Albumin in g/L is 10 times the g/dL figure (2.5 g/dL = 25 g/L). Mixing the two units is the most common slip, so check the unit printed on each result.

Try it in the Corrected Calcium Calculator→

How do I estimate creatinine clearance for renal dosing?

Many drugs are cleared by the kidney, so the dose is adjusted to estimated clearance. Cockcroft-Gault uses age, weight and serum creatinine. It estimates clearance rather than measuring GFR, so the order, the pharmacist and a current drug reference decide the actual adjustment.

Creatinine clearance (Cockcroft-Gault)

Clearance rises with age-adjusted weight and falls as serum creatinine rises; multiply by 0.85 for women.

CrCl (mL/min) = [(140 − age) × kg × (0.85 if female)] ÷ (72 × serum creatinine mg/dL)

Worked example

  1. Woman, 60 years, 70 kg, serum creatinine 1.0 mg/dL.
  2. (140 − 60) × 70 × 0.85 = 80 × 70 × 0.85 = 4,760
  3. 72 × 1.0 = 72; 4,760 ÷ 72 = 66.1

Answer: about 66 mL/min

Least reliable at weight extremes, in acute kidney injury and in the very elderly. Pounds convert to kilograms by dividing by 2.2. Which weight to use (actual, ideal or adjusted) follows the drug reference; the ideal body weight calculator shows the other two.

Try it in the Creatinine Clearance Calculator→

Which labs change what a nurse does?

The NCLEX asks whether a value should change your next action, not whether you can recite a table. This list gives the action and where to study it; the numbers come from your lab.

Labs, why they matter at the bedside, and where to study them
LabWhat it changesStudy it
PotassiumBoth high and low values can disturb the heart rhythm, so a result is read alongside the monitor and the medications. Concentrated potassium is never pushed; it is a high-alert medication.Fluid and electrolyte guide
SodiumReflects water balance more than salt intake, and changes show up as neurologic signs. Chronic imbalances are corrected at the ordered rate, not faster: correcting chronic low sodium too quickly risks osmotic demyelination, so report a rapid rise.Fluid and electrolyte guide
CalciumPart is bound to albumin, so a low albumin lowers the total. Check the albumin before calling a total calcium low; a corrected value is only an estimate, and an ionized calcium settles it. Low calcium is assessed at the bedside with Chvostek and Trousseau signs.Corrected calcium calculator
Chloride and bicarbonateWith sodium they give the anion gap, one clue in sorting out a metabolic acidosis.Anion gap calculator
Creatinine and BUNCreatinine is the more specific kidney marker; BUN also rises with dehydration. Creatinine feeds the clearance estimate behind renal dose adjustment.Creatinine clearance calculator
AlbuminChanges the interpretation of both calcium and the anion gap, so check it before reading either.Lab values for the NCLEX

Concentrated potassium appears on the ISMP high-alert medications list (2024), so facilities add safeguards such as premixed bags, infusion pumps and independent double-checks.

Where can I practice lab and electrolyte questions?

Reading a formula is not the same as applying it to a stem. Work original practice questions, each with a written rationale, then review the guides.

Frequently asked questions about lab formulas

Anion gap (mEq/L) = sodium − (chloride + bicarbonate). With sodium 140, chloride 104 and bicarbonate 12 mEq/L, the gap is 140 − 116 = 24. Whether that is high or low is judged against the reference interval printed on your lab report, because each lab and assay sets its own.

Albumin is the largest unmeasured anion, so a low albumin lowers the measured gap and can hide a real rise. A common adjustment adds 2.5 mEq/L for every 1 g/dL of albumin below 4.0. An observed gap of 10 with an albumin of 2.0 g/dL becomes 10 + 2.5 × 2 = 15. The 2.5 slope comes from Figge and colleagues (1998); the reference albumin differs between sources.

In conventional units, corrected calcium (mg/dL) = measured calcium + 0.8 × (4 − albumin in g/dL). A calcium of 7.6 mg/dL with an albumin of 2.5 g/dL gives 7.6 + 0.8 × 1.5 = 8.8 mg/dL. The SI form is measured calcium (mmol/L) + 0.02 × (40 − albumin in g/L). It is an estimate, and an ionized calcium measures the active fraction directly.

Divide the mg/dL value by 4.008 (calcium's molar mass is 40.078 g/mol, so 1 mmol/L is about 4.008 mg/dL). A corrected calcium of 8.8 mg/dL is about 2.20 mmol/L. Convert albumin separately: 1 g/dL equals 10 g/L.

Cockcroft-Gault: CrCl (mL/min) = [(140 − age) × weight in kg × (0.85 if female)] ÷ (72 × serum creatinine in mg/dL). For a 60-year-old woman, 70 kg, with a creatinine of 1.0 mg/dL: 80 × 70 × 0.85 = 4,760, and 4,760 ÷ 72 is about 66 mL/min. It estimates clearance rather than measuring GFR, and the drug reference decides any dose change.

It depends on the lab. Reference intervals vary by laboratory, assay, age and patient population, so this page does not print a fixed table. Use the interval shown on the patient's own lab report or your facility's reference, and treat a number from any study site, including this one, as a starting point for questions rather than an answer.

The ones tied to an action: potassium (heart rhythm and which medications to hold or question), sodium (neurologic checks and the pace of correction), calcium (corrected for albumin, then neuromuscular signs), and creatinine (renal dose review). The lab values guide and the fluid and electrolyte guide on this site work through each with practice questions.

Use the free medical-surgical practice questions, each with a written rationale, and the med-surg study guide. The fluid and electrolyte guide covers the sodium, potassium, calcium and magnesium patterns the NCLEX tests.

Sources

  • Figge J, Jabor A, Kazda A, Fencl V. Anion gap and hypoalbuminemia. Crit Care Med. 1998;26(11):1807-1810.
  • Payne RB, Little AJ, Williams RB, Milner JR. Interpretation of serum calcium in patients with abnormal serum proteins. Br Med J. 1973;4(5893):643-646.
  • Slomp J, van der Voort PH, Gerritsen RT, Berk JA, Bakker AJ. Albumin-adjusted calcium is not suitable for diagnosis of hyper- and hypocalcemia in the critically ill. Crit Care Med. 2003;31(5):1389-1393.
  • Spasovski G, Vanholder R, Allolio B, et al. Clinical practice guideline on diagnosis and treatment of hyponatraemia. Eur J Endocrinol. 2014;170(3):G1-G47.
  • Cockcroft DW, Gault MH. Prediction of creatinine clearance from serum creatinine. Nephron. 1976;16(1):31-41.
  • Institute for Safe Medication Practices (ISMP). List of High-Alert Medications in Acute Care Settings (2024), which includes concentrated potassium chloride.

Educational use only; verify against your facility’s policy and a current reference before acting on any lab value.

Free · no spam

Get a free high-yield NCLEX question every week

One carefully written practice question plus a short study tip, emailed weekly. Unsubscribe anytime — we never share your address.